Ductwork Design & Static Pressure Balancing in the Tulsa Metro

Static pressure, explained simply

Think of your duct system like a garden hose. If you pinch the hose, water still comes out, but the pump has to push much harder. Static pressure is how hard your blower has to push to move air through the filter, coil and ducts.

Every system has a range it is designed to work in. When ducts are too small, crushed or tangled, or the filter is too restrictive, pressure climbs. Airflow drops, rooms get uncomfortable, and the blower and compressor wear out sooner. We measure it with a gauge, so we work from real numbers, not guesses.

Common duct problems we find

Many homes in Sapulpa and Tulsa have duct systems that were never quite right, or that were changed during a remodel. Attics here get extremely hot in summer, so leaks and thin insulation cost more than you might think.

• Undersized supply or return ducts
• Not enough return air for the size of the system
• Disconnected, crushed or kinked flex duct
• Leaky joints and seams in the attic or crawlspace
• Poorly insulated ducts that sweat or lose heat
• Added rooms without enough supply air

Redesigns, retrofits and balancing

Sometimes the fix is small, like adding a return, resizing a run or sealing leaks. Other times, the best answer is a partial or full redesign that matches the duct system to the equipment and the house.

After the work, we balance the system by adjusting dampers and checking airflow so each room gets its share. Every new system we install also gets a static-pressure check and balancing, because new equipment on bad ducts can't deliver what it promises.

Honest recommendations

We will show you the readings and explain what they mean before suggesting any work. If your ducts are in good shape, we will tell you. If a simpler fix gets you most of the way there, we will start there. That is how we treat our own family, and it is how we treat yours.